stanley electric sharpshooter staple gun instructions

Stanley electric sharpshooter staple gun instructions how to#
Stanley electric sharpshooter staple gun instructions free#

You can either use staples or nails with a Stanley staple gun. When you are operating a power tool, ensure that you use an outdoor extension that is marked “W” or “W-A.” These are the cords that are rated to be used outdoors and they help to reduce risks of electric shock.

Make sure that damaged cords are immediately replaced as this increase the risk of electric shock Ensure that the cord is away from oil, heat, moving parts, and sharp edges. This means that you should not use the cord to carry the tools or plug from an outlet. If water or moisture enters power tools, this increases the risk of electric shock. Do not expose any power tool to rain or wet conditions.This is because contact increases the risk of electric shock if the body is grounded Ensure that you avoid any body contact with grounded surfaces such as refrigerators, ranges, pipes, and radiators.Double insulation helps to eliminate the need for the three-wire grounded power cord and grounded power supply system However, if the plug still fails to fit, ensure that you contact a qualified electrician for the installation of a polarized outlet. If the plug fails to fit fully in the outlet, you ought to reverse the plug. This plug fits in a polarized outlet only one way. Tools with double insulation are equipped with a polarized tool, which means that one blade is wider compared to the other.

Stanley electric sharpshooter staple gun instructions how to#

Read more10 Common Staple Gun Problems and How to Fix Them Distractions can lead to the user losing control, and this can cause accidents Ensure that children, visitors, and bystanders are kept away while you operate this power tool.Power tools tend to create sparks and this can cause the ignition of fumes or dust

Stanley electric sharpshooter staple gun instructions free#

This is to means that where you are operating the tool should be free of flammable gases, liquids, or dust.

You should not operate in an atmosphere that is explosive.

Working areas that are cluttered and dark is a way of inviting accidents

Ensure that your working area is clean with enough light.

It is important to follow the instructions below to prevent cases of electric shock, misfiring, and causing serious injury to the user: Lastly, apply adequate pressure on the top of the knob while pulling the trigger. The on the switch should be turned to position 1 and ought to be held firmly against the work surface to ensure there is the engagement of the safety mechanism. Note: When you are using staples or nails on a Stanley staple gun, ensure that the on/off switch is in the off position and plug stapling tacker in. Also, it is important to ensure that you use low/high power when you are driving brads. If the staple gun is jammed or there is misfiring, repeat the steps above to ascertain that you have loaded the staple gun effectively. Test the staple gun with two brads to ascertain the firing is okay.